Magma P13RR-TEL User Manual download pdf (Page 23)

MAGMA

Chapter 4 Install 3

Party PCI Cards 15

Finishing Touches

After your system is working properly, replace any empty slots with slot

covers, and install the card hold down retainers that shipped with your

expansion system.

The P13RR-TEL includes a PCI card

hold down bar and set of plastic

retainers to provide an extra method

of securing the PCI cards in the

chassis. This is especially useful

when transporting a fully-loaded

expansion chassis.

The PCI cards in your chassis can easily be held firmly in place in a

couple of simple steps.

1. Select either the

long or short Retainer, depending on

the height of your PCI card.

2. Squeeze the open end of the Retainer and insert it, from the

bottom of the bar, into an open slot directly above your PCI

card. When the round tips on the end of the Retainer are inline

with the round holes on the bar, release the Retainer.

3. Next, squeeze the open end of the Bracket

and insert it

(from the top) into the bar so that the round holes on the

Bracket align with the round tips inside the bar. When aligned,

release the Bracket. The Bracket should move freely.

4. Take the Screw

and insert it

through the slot in the edge

of the bar so that it will align

with the threaded opening in

the closed end of the Bracket

and start to thread it by

turning it clockwise.

5. You will notice that the threading action will start to adjust the

closed end of the Retainer toward the PCI card directly below.

Continue to tighten the Screw until it fits snuggly onto the top of

the PCI card.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

No comments

Magma P13RR-TEL User Manual Page 23