Magma PE6R4 User Manual download pdf (Page 14)

MAGMA

6 Chapter 2 Hardware Installation

Connect cables to

the chassis.

Connect cables to

the host card.

When properly installed, each cable will have matching labels at both

ends (x1 to x1 and x3 to x3).

CAUTION

All cables attached to the expansion chassis must be securely

fastened. When you hear a “click,” it is properly secured. If not

securely connected, the connectors may cause intermittent or lost

connections.

Connect the power cord to the power-in receptacle located at the rear of

the enclosure.

NOTE

If at all possible, plug all power cords from the expansion chassis

and your host computer into a shared power strip, preferably one

that has surge and noise suppression circuitry built into it.

Recheck the Installation

Check your installation before powering up the Magma expansion

chassis for the first time. Although the power supply has an over voltage

protection device built into it, it may not "trip" in time to fully protect a

device that has been improperly connected, or whose power cable has

been damaged.

CAUTION

This product is provided with a power supply that automatically

adjusts to input voltages between 100 to 240 Vac. A U.S. and

Canadian 125 V power supply cord is provided with this product. If

using this product outside of the U.S. or Canada, please use locally

available power supply cords

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

No comments

Magma PE6R4 User Manual Page 14